The investigator is using non-contact 3D measurement technologies for data collection. The data is processed, analyzed and prepared for presentation in the software Scopos Investigator Suite. The operator of the investigator receives the processed data immediately on his/her computer. The operator can easily make the desired measurements of the depth from camera to object and the distance between point A and B of his/her wish. The investigator has recording feasibility which enables the possibility to store data for later use and new research and for documentation if required.

HD-camera technology of high quality is used for the purpose of navigation to desired measurement area. It also provides a high resolution picture/film of the equipment to be monitored and measured.

The software Scopos Investigator suite is tailor made for Scopos Investigator. It is module based and can be set up according to customers need for flexibility. Pre-sets, different filters and adjustments are available for the 3D camera, HD camera and lights. The software enables the same conditions for measurement in real time and on recordings.

The Scopos investigator is built as smooth as possible to be able to monitor and investigate inaccessible areas. The investigator is available in depth rate of 250 meter and 1500 meter. The differences in temperature are maintained and controlled by the software and electronic equipment.

Customers are recommended the Scopos Investigator if there is a need for quick, cost effective decision making based on geometric measurements above and below sea level.

Down load datasheet:

Investigator_english.pdf3.67 MB